Measurements for the bezel which can hide the 30 pin charger.
The bezel for the screen in the prototype is fortunately wide enough to accommodate a number of things I need to hide. Specifically, the iPad charger. I found a old 30 pin charger with a right angle connector.
The bezel will also need to have a hole for the iPad home button. I still need to work out volume controls.
Ideally the bezel would have the profile shown below. I was planning on use a wood picture frame, but I’m having a hard time finding one that is 36mm on the top/bottom, but only 30mm on the sides.
I may attempt to repurpose a iPad picture frame or an iPad enclosure or here.
Related
Feb 1 2015
Bezel Design for prototype
Measurements for the bezel which can hide the 30 pin charger.
The bezel for the screen in the prototype is fortunately wide enough to accommodate a number of things I need to hide. Specifically, the iPad charger. I found a old 30 pin charger with a right angle connector.
The bezel will also need to have a hole for the iPad home button. I still need to work out volume controls.
Ideally the bezel would have the profile shown below. I was planning on use a wood picture frame, but I’m having a hard time finding one that is 36mm on the top/bottom, but only 30mm on the sides.
I may attempt to repurpose a iPad picture frame or an iPad enclosure or here.
Related
By jeffsrule • Mac, Pomona Curved, Prototype • 0 • Tags: Bezel, iPad